Product Name: ZBQ-27/1.5 coal injection pump for use with pneumatic pneumatic coal injection pump ZBQ-27/1.5 rules: 1. Ensure gas supply without excessive moisture and dirt to ensure gas supply lubrication system . I plant to provide optional lubricator. 2 gas supply pipe should be connected to a vent pipe, blowing debris, and then connect with the injection pump and reliable. 3 first port dipped into the slurry pump clean water, slowly open the inlet valve, to ensure smooth grouting pipe, seal leak. 4. Pump fluid should be mixed, no clumps, but thick. Promptly clean up bucket corners and sides solidified material, in order to avoid falling into the slurry. 5 stock inlet of the pump immersed in the slurry, slowly open the inlet valve, gradually increasing to grouting speed matters. 6. Pump should immediately stop working after dipped in clean water rinse, and slowly open the inlet valve, until discharge slurry pipe clean water discharged slurry-free so far. 7 After cutting off the gas source and drain slurry pipe, regularly breaking the U-shaped card on the grouting cylinder, out grouting cylinder, complete removal of residual grouting materials, water washed repeatedly. 8 After cleaning the metal surface coated with grease cylinder grouting and re-tighten the pump connection. 9 Do not make the injection pump load or light load high-speed operation, in order to avoid damage to the active component. 10 Gas supply pressure must not exceed 0.8Mpa. 11 at the construction site should be made into slurry injection pump erected placed mouth down to avoid the intake pipe fittings and exhaust hood into the debris. If you have any questions about the coal mine ZBQ27/1.5 pneumatic injection pump, please further contact with the company to get coal mine. Contact: Wu Jingli Mobile: 18653822725 landline :0538-8530018 QQ: 635395409 Fax 0538 -8530316